TMSS10MergeXML merges XML files at specific nodes.
TMSS10MergeXML [-c configuration file] [-e XML encoding] [-h write XML header] [-r add XML root node] [-s stylesheet]
-c
The config file argument specifies the path to the Batch Configuration File. The Batch Configuration File allows you to perform advanced traversal of Customer, Media and Volumes, perform advanced Barcode pre and post processing and route program output to syslogd. Configuration File capabilities vary from program to program but the syntax remains the same. In the event that logic is not supported it will simply be ignored.-e
XML Encoding (default = iso-8859-1).-h
Write XML Header (default = false).-r
Add this XML root node.-s
Stylesheet
If an argument value starts with the value FI:
, the value for that attribute will be read from the file name specified immediately after it. For example, if a file named ACME_volumes has the content ACME_*.*
, specifying FI:/etc/ACME_volumes
will have the same effect as -V ACME.*.*
. Using FI:
to refer to a file for an attribute value works for all attributes.
If the pattern being matched starts with *LIST: then rather than matching the literal value, each record in the file specified as *LIST:filename will be tested. If one matches the match will succeed.
The TapeTrack Software is commercially supported by a full time help desk staff.
If you are experiencing problems or want some advice on how to configure or use the product please see the Accessing Technical Support page.
stdout: Output Reports.
stderr: Diagnostic messages.
stdin: Program input.